Hi there dc42, I think those pins are already in the correct place since I traced each pin from the ramps board so that I could just connect directly to the Arduino.
My theory being; If I can view the marlin firmware on the LCD, then I know my wires re in the right place as far as Marlin is concerned...
So If I knew which pins Marlin uses to talk to the LCD, then I'd know what to send to u8glib...
Aside from that, do you have any recommendation for which library I should use?
My intention is to have a menu system navigated with the said Encoder, and then to have 240v relays switch on and off...
So if you have an alternative solution for my project, please leave me some information...
Thank you
My theory being; If I can view the marlin firmware on the LCD, then I know my wires re in the right place as far as Marlin is concerned...
So If I knew which pins Marlin uses to talk to the LCD, then I'd know what to send to u8glib...
Aside from that, do you have any recommendation for which library I should use?
My intention is to have a menu system navigated with the said Encoder, and then to have 240v relays switch on and off...
So if you have an alternative solution for my project, please leave me some information...
Thank you