@ dc42..
Thank you for your answer!
After reading your comment i came up with this: Ima hook everything up with the steppers i got so i can start too "program" or "code" or whatever you call it when you "program" your electronics (Arduino microkontrollers etc).
When i orderd the parts i wanted the most amp possible too the motor since i had no clue how much i really needed... (Going with a big, clumpsy and heavy build).
Since i wont "fry" my electronics ill go ahead with testing and programing :D
But ill order the steppers you recommended and install them before testing the motors under "load" (On the frame, going too test electronics loose on my desk before installing it too the frame).
Again.. Thank you for you answer! Best regards /Patrik Sundén (:D
Thank you for your answer!
After reading your comment i came up with this: Ima hook everything up with the steppers i got so i can start too "program" or "code" or whatever you call it when you "program" your electronics (Arduino microkontrollers etc).
When i orderd the parts i wanted the most amp possible too the motor since i had no clue how much i really needed... (Going with a big, clumpsy and heavy build).
Since i wont "fry" my electronics ill go ahead with testing and programing :D
But ill order the steppers you recommended and install them before testing the motors under "load" (On the frame, going too test electronics loose on my desk before installing it too the frame).
Again.. Thank you for you answer! Best regards /Patrik Sundén (:D