Yes, that video. I'm not sure how you can not fully agree. I just basically rephrased exactly what he says. At about the 2:15 mark he talks about the quiet mode and describing it as "gently suggesting that now maybe it should move to that spot and if it doesn't, the driver isn't going to take any extra efforts to get it there" and then follows it up demonstrating minimal torque by stopping and pushing the x-carriage the opposite direction intended, and then just flat out saying it makes it pretty useless for our use with 3D printers. He even shows in the datasheet where it says only for low and medium velocities. Seems pretty cut and dry.
↧
Re: TOS-100 stepper driver (autodiagnostics, up to 1/256steps etc.) why nobody tried?
↧