Looking for advice of organizing wires.

Hi,

This is my first Reprap 3D Printer, Mini Kossel.
It's almost done and I'll organize all loose wires and make it a finished machine.

I'll print a plastic case for the controller unit, and build 12 cm height of base that houses the modified ATX PSU.

I was going to install the controller unit on top of the frame but two stepper motor's wires were too short.
I disliked spending few hours just to make long wires yesterday.


I'll install RepRapDiscount Smart Controller.
Extra components I've added:
- Dedicated 12V DC fan for the controller board.
- 100 ohm variable resistor that controls speed of the board fan.
- Two blade type fuse holders, these are freaking big.
- +5V auxiliary power from the PSU


Regards,
Hughe