Shes's alive!
It was a hardware problem! I didn't have 5V on pin 9, I corrected a bridged joint and as soon as I applied power the SetupTest ran.
The heater LED isn't blinking, but I'm a long way from needing that!
I uploaded the SetupTest again just to make sure communication was working, and it went in first time, and the serial monitor reported the progress.
Next step is to install teacup and get my motors moving!
Thanks Traumflug! If I can build this anyone can.
It was a hardware problem! I didn't have 5V on pin 9, I corrected a bridged joint and as soon as I applied power the SetupTest ran.
The heater LED isn't blinking, but I'm a long way from needing that!
I uploaded the SetupTest again just to make sure communication was working, and it went in first time, and the serial monitor reported the progress.
Next step is to install teacup and get my motors moving!
Thanks Traumflug! If I can build this anyone can.