The default mosfet of RAMPS BOM mightnot work well for 3.3v but as said planning for using an external one already...
The SD extension board designed for RAMPS might not work because of the voltage translator.
Other than that, it should work.
Though dont understimitate the software issue, u might end up rewriting the whole firmware, not an easy job.
p.S. I am working on writing a firmware for Arduino Due.
The SD extension board designed for RAMPS might not work because of the voltage translator.
Other than that, it should work.
Though dont understimitate the software issue, u might end up rewriting the whole firmware, not an easy job.
p.S. I am working on writing a firmware for Arduino Due.