ill put this one in not finished built my 3d printer yet but hear goes
1.Hacked Xbox 360 With switch and Fan
2. 203w had 3 12v rails maybe four two wires was spliced together made it into two 12 volt rails wired straight to my ramps connector
(prob two power supplys later on)
3.16.5 amps (newbie to electronics so i dont understand if the bed is suppose to be powered from ramps and you have a 5amp and a 11amp input surely the ramps is rated a 16amp board), but slightly understand that it not just about amps it about the stability of the current flow so i suppose i will later on get another
4. have not got one yet till having trouble how to mount it into m4 tapped holes
5. marlin
6. unknown
7. unknown
1.Hacked Xbox 360 With switch and Fan
2. 203w had 3 12v rails maybe four two wires was spliced together made it into two 12 volt rails wired straight to my ramps connector
(prob two power supplys later on)
3.16.5 amps (newbie to electronics so i dont understand if the bed is suppose to be powered from ramps and you have a 5amp and a 11amp input surely the ramps is rated a 16amp board), but slightly understand that it not just about amps it about the stability of the current flow so i suppose i will later on get another
4. have not got one yet till having trouble how to mount it into m4 tapped holes
5. marlin
6. unknown
7. unknown