Thank you Ceflar, Ill check for a short which is a way better fault than a faulty thermistor,
its a hell to get to the cables again as they are full of capton tape, but your suggestion to look closely for spikes while printing with auto stop disabled is quite a better way to pinpoint the faulty behavior :)
the short would probably be near the hotend where everything heats up considerably, wont be?
its a hell to get to the cables again as they are full of capton tape, but your suggestion to look closely for spikes while printing with auto stop disabled is quite a better way to pinpoint the faulty behavior :)
the short would probably be near the hotend where everything heats up considerably, wont be?