Ah sorry everyone, versions got a bit out of sync.
RAMPS-FD.pro is the correct project, but the board file is RAMPS-FD-v3.brd. I'll try to tidy this up on next revision :)
@Cameron, there are 6 steppers, the PDF was out of date. I have uploaded a new PDF to match the schematic. I am planning an expansion board to handle even more stepper/extruders.
@Cefiar, for the prototype I used smallish traces to help the autorouter. For proper version I will use thicker traces or filled planes.
RAMPS-FD.pro is the correct project, but the board file is RAMPS-FD-v3.brd. I'll try to tidy this up on next revision :)
@Cameron, there are 6 steppers, the PDF was out of date. I have uploaded a new PDF to match the schematic. I am planning an expansion board to handle even more stepper/extruders.
@Cefiar, for the prototype I used smallish traces to help the autorouter. For proper version I will use thicker traces or filled planes.