Hi,
I installed a thermocouple in my prusa with a megatronics v. 1.0.
To avoid flickering I put a 10nK100 capacitor on the thermocouple.
Now the problem:
when the extruder is cold the thermocouple gives 6.8 degrees but the room is at 19 degrees.
Does the thermocouple is working?
I installed a thermocouple in my prusa with a megatronics v. 1.0.
To avoid flickering I put a 10nK100 capacitor on the thermocouple.
Now the problem:
when the extruder is cold the thermocouple gives 6.8 degrees but the room is at 19 degrees.
Does the thermocouple is working?