Quote
angelo
Which Firmware is used für the RAMPS-FD?
Have fun
angelo
Reading though this forum turns up:
- Bobc's port of R2C2
- APrinter (developed by me)
- Perhaps some form of RepetierFirmware, see this post by bobc.
I have yet to test R2C2, I only know that my APrinter works reliably (as far as I can tell) on my improvised setup which should be pin-compatible with RAMPS-FD. So I'll just assume it works on an actual RAMPS-FD until someone tells me otherwise. ;)
Note that R2C2 doesn't support SD card yet, so I have to selfishly recommend APrinter if you want reliable stand-alone printing.