lets share info. I am having issues with merlin, complier errors
you problem I believe is that your motors can run that fast at that current. try first to lower the x,y,z feed rate real slow say 10 mm / sec
then move the motors, you should not be able to stop the motors by hand, if you can turn up the power.
the motors will make noise but will be strong. Mine is ok now.
Don't worry about steps etc, unless you have them calibrated, at this point.
tech guy
you problem I believe is that your motors can run that fast at that current. try first to lower the x,y,z feed rate real slow say 10 mm / sec
then move the motors, you should not be able to stop the motors by hand, if you can turn up the power.
the motors will make noise but will be strong. Mine is ok now.
Don't worry about steps etc, unless you have them calibrated, at this point.
tech guy