I am even more confused, because with my older hotend I have measured the voltage to be around 11.2V
Is this because my new hotend has two resistors? Am I correct? Is that why there is two holes on both sides of the alu block to evenly warm up the hotend? And is this why there is a naked crimped wire sticking out of the hotend on the front?
Hmm, things start to make sense, thanks!
I will re-read tomorrow because I still don't feel like I am able to safely make a table.
Is this because my new hotend has two resistors? Am I correct? Is that why there is two holes on both sides of the alu block to evenly warm up the hotend? And is this why there is a naked crimped wire sticking out of the hotend on the front?
Hmm, things start to make sense, thanks!
I will re-read tomorrow because I still don't feel like I am able to safely make a table.