Hi guys,
I posted the start of my problem in the General part of the forum, now I am hoping to move it here for more detailed help. I am new to the Reprap world and am finishing my first build of a Prusa i3. I have noticed my extruder motor is not even close to working properly. Upon further testing, it is apparent the stepper driver is bad for the extruder motor.
I have RAMPS 1.4 with Marlin software. I have a total of 5 stepper drivers and four are being used. My question is, how do I configure the software to treat the unused stepper driver for the extruder? I am pulling my hair out. This is probably a basic question but I searched all over and can't find an answer! Please help if you can!!!! I need it!!!
I posted the start of my problem in the General part of the forum, now I am hoping to move it here for more detailed help. I am new to the Reprap world and am finishing my first build of a Prusa i3. I have noticed my extruder motor is not even close to working properly. Upon further testing, it is apparent the stepper driver is bad for the extruder motor.
I have RAMPS 1.4 with Marlin software. I have a total of 5 stepper drivers and four are being used. My question is, how do I configure the software to treat the unused stepper driver for the extruder? I am pulling my hair out. This is probably a basic question but I searched all over and can't find an answer! Please help if you can!!!! I need it!!!