Dont think those would work fine with usual pololu drivers. First off, two of them have 52ohms resistance and 0.23A current, those are pretty much the wrong type. The others two are 8.9ohms and 0.561A, that is slight improvement but not by much.
Ideally would need something like 4ohms or less, and current to 1A or more. I would take a regular reprap motor, add a screw to their shaft, and just use it like that.
Ideally would need something like 4ohms or less, and current to 1A or more. I would take a regular reprap motor, add a screw to their shaft, and just use it like that.