I figured I had an incorrect board link and that it would be more trouble than I would care for :( As far as using the 1796 board, do you know of any additional documentation beyond the Smoothie on a breadboard page? Part of wanting to go the DIY breadboard route for me is wanting to use the 8825 stepper drivers and wondering if it's possible to hook up more than 5 stepper drivers. The Azteeg X3 Pro looked nice except I'd like to stick with an ARM chip. There is a 5 driver version of the X5 in the works but it won't be available for a little bit and Smoothieboards still aren't available. If the breadboard solution allows me to use drivers I want, higher voltage supplies for them, more drivers total and without a lot of software/firmware tweaking then I'd prefer to build it myself. Thanks for any other help you might provide.
↧