I just purchased an Azteeg X3 Pro controller board which has 8 stepper drivers on the board. I haven't gotten yet but wanted to start researching and planing.
I'm planing on retrofitting a Z corp powder printer with this board and a double head extruder. The x and y axis use one stepper, and one each for the extruders. The Z axis uses four steppers, one on each corner of the bed. Total of 8 steppers. Since the board can drive 8 steppers, can I synchronize 4 drivers on the board to drive the z axis steppers?
Tim
I'm planing on retrofitting a Z corp powder printer with this board and a double head extruder. The x and y axis use one stepper, and one each for the extruders. The Z axis uses four steppers, one on each corner of the bed. Total of 8 steppers. Since the board can drive 8 steppers, can I synchronize 4 drivers on the board to drive the z axis steppers?
Tim