Hi JNOD
The picture on the blog for the adapter is correct, solder the pads closest to the 6x2 ribbon cable socket for a directly connected encoder.
You are right the newer version has a 4 point solder jumper, bridge the middle two for normal operation - did you board not come setup like that?
Cheers
Tony
The picture on the blog for the adapter is correct, solder the pads closest to the 6x2 ribbon cable socket for a directly connected encoder.
You are right the newer version has a 4 point solder jumper, bridge the middle two for normal operation - did you board not come setup like that?
Cheers
Tony