Can anyone expand on how the eeprom works? and/or where in the firmware the default settings are that will be loaded into eeprom when reset to defaults? I currently have eeprom disabled cause when I was calibrating my printer, I would make the e-steps change in the firmware and reflash. Worked great and then I decided to try enabling eeprom so I could make "on the fly" changes while printing but when I pull up the values,on the lcd display, assigned in the firmware they do not match the values I've changed in Configuration.h? It looks to be storing default values in eeprom written somewhere other than Configuration.h?
I would like to have eeprom enabled for real time changes but would also like the initial values it loads on default to be the ones I've calculated during calibration and changed in Configuration.h.....anyone know how to accomplish this?
I would like to have eeprom enabled for real time changes but would also like the initial values it loads on default to be the ones I've calculated during calibration and changed in Configuration.h.....anyone know how to accomplish this?