OOOH!
Congratulations...is actually very good...:D...is it PLA or ABS? I am having a terrible time with ABS...X(
Maybe you want to have a look at this: http://reprap.org/wiki/Print_Troubleshooting_Pictorial_Guide
Your "wobbliness" problem is, unfortunately, not listed 8-) but it might be caused by excessive pressure in the exit of the nozzle. I would try to calibrate the extruder motor to make sure it is not pressing too much...
Happy printing! :D
Congratulations...is actually very good...:D...is it PLA or ABS? I am having a terrible time with ABS...X(
Maybe you want to have a look at this: http://reprap.org/wiki/Print_Troubleshooting_Pictorial_Guide
Your "wobbliness" problem is, unfortunately, not listed 8-) but it might be caused by excessive pressure in the exit of the nozzle. I would try to calibrate the extruder motor to make sure it is not pressing too much...
Happy printing! :D