Hi Ketil
No worries! As far as the heated BEd PSU is concerned that sounds fine, most "standard" heated beds only draw around 12A or so at 12V. That heating sounds about right - the normal things apply like if you are going to put it in a sealed box then ensusre you have some airflow through. The Main voltage in can be between 12V and 24V without problems, the motor drivers are current limiting so they will work fine with that range. Your heaters will obviously heat quicker with 24V and you will see quite a bit of overshoot on the hotends if you dont modify the PID values. Also at 24V a standard cartridge heater will get very hot very quickly so be careful not to have the thermistor fall out of the hotend.
Dc42 and iamburny over on the Ormerod forums added the features to improve the SD card upload and the new web interface is great!
No worries! As far as the heated BEd PSU is concerned that sounds fine, most "standard" heated beds only draw around 12A or so at 12V. That heating sounds about right - the normal things apply like if you are going to put it in a sealed box then ensusre you have some airflow through. The Main voltage in can be between 12V and 24V without problems, the motor drivers are current limiting so they will work fine with that range. Your heaters will obviously heat quicker with 24V and you will see quite a bit of overshoot on the hotends if you dont modify the PID values. Also at 24V a standard cartridge heater will get very hot very quickly so be careful not to have the thermistor fall out of the hotend.
Dc42 and iamburny over on the Ormerod forums added the features to improve the SD card upload and the new web interface is great!