uha bad news ;(
but how could I shorten the thermistor input to12V?
I have a the E3D fan connected to the 12V power supply. The additional cooling fan for the PLA was added after the symptoms occured.
How can I "repair" this? Replace the arduino board or the ramps? can i replace any part on the boards?
Sorry for the many questions, I just want my bed heating up again
ah and probably the most important one, how can I prevent this from happening again?
Cheers
Axel
but how could I shorten the thermistor input to12V?
I have a the E3D fan connected to the 12V power supply. The additional cooling fan for the PLA was added after the symptoms occured.
How can I "repair" this? Replace the arduino board or the ramps? can i replace any part on the boards?
Sorry for the many questions, I just want my bed heating up again
ah and probably the most important one, how can I prevent this from happening again?
Cheers
Axel