Hey nophead,
thanks for your help.
Well I'll check the wiring, actually I was more worried on my HotEnd isolation than the one from the bed but sh... happens
Sending some pics here to check if I did something wrong - which I doubt ;) I mean all the 12V cables are isolated I am still wondering how they can shorten to the 5v IO line and the thermistors. I was worried that those tiny thermistor cables shorten and I get a false reading.
There is still one input left on the board so I will go with a pin reassign after its clear what caused the problem. Same as with a multicopter or the shuttle ... it stays in hangar until you know whats wrong ;)
Replacing the atmega is the last option but I think getting a new one for 14€ is the best choice here - my soldering skills are ok but thats too much of a headache
More infos tomorrow
Cheers
Axel
thanks for your help.
Well I'll check the wiring, actually I was more worried on my HotEnd isolation than the one from the bed but sh... happens
Sending some pics here to check if I did something wrong - which I doubt ;) I mean all the 12V cables are isolated I am still wondering how they can shorten to the 5v IO line and the thermistors. I was worried that those tiny thermistor cables shorten and I get a false reading.
There is still one input left on the board so I will go with a pin reassign after its clear what caused the problem. Same as with a multicopter or the shuttle ... it stays in hangar until you know whats wrong ;)
Replacing the atmega is the last option but I think getting a new one for 14€ is the best choice here - my soldering skills are ok but thats too much of a headache
More infos tomorrow
Cheers
Axel