The only thing differentiating this board from an Azteeg X5 Mini are the socketed stepper drivers. Am I missing something else?
Where do the heated bed and hotend heater connect? I only see two sets of screw terminals?
If it is not too late in the design process, can I suggest adding a second power input rail dedicated to the heated bed, like RAMPS and a few other boards use? Having only one power rail is my only gripe with the design of the Axteeg X5 Mini, and I am personally running an external supply and SSR to power my large Onyx heated bed. It would also be neat if you had pin-compatible interface connectors that would take RRD GLCD ribbon cables with no adapters, but that is probably asking too much.....
Where do the heated bed and hotend heater connect? I only see two sets of screw terminals?
If it is not too late in the design process, can I suggest adding a second power input rail dedicated to the heated bed, like RAMPS and a few other boards use? Having only one power rail is my only gripe with the design of the Axteeg X5 Mini, and I am personally running an external supply and SSR to power my large Onyx heated bed. It would also be neat if you had pin-compatible interface connectors that would take RRD GLCD ribbon cables with no adapters, but that is probably asking too much.....