You are right, socketed steppers are main difference between this board and Azteeg x5. I wanted to upgrade to Smoothie firmware and reuse my stepsticks, but there is no board which accept them.
Heatbed connector and transistor is not yet soldered on the board, thats why you can´t see them.
Original idea was to make a Sanguinololu clone (same dimensions and pinout). but as I already discovered, that was not a best idea. In next revision I will rearrange some of the connectors and make the board little bit wider. I can try to fit there GLCD connectors.
Heatbed connector and transistor is not yet soldered on the board, thats why you can´t see them.
Original idea was to make a Sanguinololu clone (same dimensions and pinout). but as I already discovered, that was not a best idea. In next revision I will rearrange some of the connectors and make the board little bit wider. I can try to fit there GLCD connectors.