Quantcast
Channel: Reprap Forum - Controllers
Viewing all articles
Browse latest Browse all 10211

Re: Question about 3d printer electronics, power supply

$
0
0
Based on rated values, you may be good. Now if anything is out of spec from what they are suppose to be, then you may be under powered. It's not uncommon for a power supply to be overrated, and if your bed has lower that normal resistance (<1-1.2 ohms) then it will draw more than the normally expected 10 amps.

Viewing all articles
Browse latest Browse all 10211

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>