Yes, with three on each, I have silky smooth but very slow (scaled down) movements. Curiously the printer also hits an invisible max stop in all axes.
So two questions:
1) How do I ascertain what level of microstepping I require?
2) Will this necessitate a change in the Marlin code? I have another question related to Marlin which I will ask in the correct forum.
I've found the table defining the three stepper jumper setting options here
So two questions:
1) How do I ascertain what level of microstepping I require?
2) Will this necessitate a change in the Marlin code? I have another question related to Marlin which I will ask in the correct forum.
I've found the table defining the three stepper jumper setting options here