Angelo
No not made any progress with the CoreXY and Radds yet been to busy and keep redesigning it as I am not to happy with bits and think I may do it again to use V-Groove Wheels on Makerslide for the X and Y Axis now so going to build a D400 Delta first.
I already have a 400x400 silicon 220Volt heater and a SSR so I could use that without to much difficulty and just mount the bed slightly differently.
Might also build the CoreXY with a E3D Cyclops Mixing Extruder This will be a neat solution for multi coloured printing I think and very small footprint and easier to mount on a Makerslide system.
Doug
No not made any progress with the CoreXY and Radds yet been to busy and keep redesigning it as I am not to happy with bits and think I may do it again to use V-Groove Wheels on Makerslide for the X and Y Axis now so going to build a D400 Delta first.
I already have a 400x400 silicon 220Volt heater and a SSR so I could use that without to much difficulty and just mount the bed slightly differently.
Might also build the CoreXY with a E3D Cyclops Mixing Extruder This will be a neat solution for multi coloured printing I think and very small footprint and easier to mount on a Makerslide system.
Doug