Bit of a mediocre day shopping for parts yesterday. The closest I could get was 2 x 33R and 2 x 39R power resistors. I'm fairly sure they're 3W and 5W judging by their size. The plan is to use the 2 x 33R on the 2 x 5V connections, and the 2 x 39R in parallel across the 3.3V. These are the resistors in question, I put a standard 1/4W resistor in the middle for size comparison:
![339rep5.jpg]( "339rep5.jpg")
I'm still not sure about the wires coming from the heatbed. Should I replace them with something thicker?
I'm still not sure about the wires coming from the heatbed. Should I replace them with something thicker?