Hi there,
I got a new Ramps 1.4 board, Mega controller, Full graphic display and 5 stepper drivers for a Prusa i3 build I am putting together.
I was wiring the motors, hot end and end stops in to the Ramps board and then when I clicked the three end stops, the full graphic display shut off and I could smell a burning smell?
After this happened, the display will only come on after the ramps/mega are plugged in to PC USB power (the controller can be connected to in Repetier).
Can anyone give me any advice on what might have happened? I bought the set off Amazon, the manufacturer is called SINTRON.
Kindest regards,
Nathan
I got a new Ramps 1.4 board, Mega controller, Full graphic display and 5 stepper drivers for a Prusa i3 build I am putting together.
I was wiring the motors, hot end and end stops in to the Ramps board and then when I clicked the three end stops, the full graphic display shut off and I could smell a burning smell?
After this happened, the display will only come on after the ramps/mega are plugged in to PC USB power (the controller can be connected to in Repetier).
Can anyone give me any advice on what might have happened? I bought the set off Amazon, the manufacturer is called SINTRON.
Kindest regards,
Nathan