Hi there,
I attached the X motor to the other axis slots and the X motor works in all positions (Y and Z) So the pololus are not the issue.. I have tried switching one of the coils on the offending motors as well.. But no different.. I can get them to twitch once.. but then they do nothing until the board is rebooted. Surely this means that the motors should be ok?
Have anyone come across this before?
Nathan
I attached the X motor to the other axis slots and the X motor works in all positions (Y and Z) So the pololus are not the issue.. I have tried switching one of the coils on the offending motors as well.. But no different.. I can get them to twitch once.. but then they do nothing until the board is rebooted. Surely this means that the motors should be ok?
Have anyone come across this before?
Nathan