Re: Firmware to drive X-Y galvanometer

Hi Bob.

Please, excuse me, anythin wrong last nigth with the shift key or on my mind!!!!!:S

I resend the post adequately.

Hi pleople, as i tell you on my other :(.....im looking for start my sla printer, but have a lot of dudes..

i see that the galvos option, will be faster and perhaps could have much resolution than a single cartesian system, but i dont know if the galvo system could scan a good area from about 1m x1m, to cover this so great area will cause a distortion of the laser, given its inclination at the ends.???

Other option is a simply carteisan system by transforming a cheap co2 laser machine that have an up an dow platform too, it can be runing of about 5000mm/s max ..

If anybody can help me will be apreciate.

Dont konow if Kelton finally try the galvos or not..


Thanks at all and excuse my last post:X and my bud english...

Regards

Fernando