Hi Roy,
Thanks for the prompt response. I do have the cover as in the pict above, so I'll try my fan in the H-END3 (D16) connector as you suggest.
One final question... In Marlin do I simply change the "-1" to "16" in the " #define HEATER_2_PIN -1 " line, in Pins.h tab (MOTHERBOARD == 34 section)?
What g-code command will switch on the fan? I presume M42 P16 S255?
Thanks again!
Ivor
Thanks for the prompt response. I do have the cover as in the pict above, so I'll try my fan in the H-END3 (D16) connector as you suggest.
One final question... In Marlin do I simply change the "-1" to "16" in the " #define HEATER_2_PIN -1 " line, in Pins.h tab (MOTHERBOARD == 34 section)?
What g-code command will switch on the fan? I presume M42 P16 S255?
Thanks again!
Ivor