I noticed a cheaper fuse holder at Digikey [www.digikey.com] which we could consider for a Rev B. This is a similar type to the one used on RAMBo.
I was thinking that Geetech could reduce inventory by using the same component, but if you look at their RAMBo [www.geeetech.com], it has a fuse directly soldered to the board! I think Geetech are not quite getting the point :(
I was thinking that Geetech could reduce inventory by using the same component, but if you look at their RAMBo [www.geeetech.com], it has a fuse directly soldered to the board! I think Geetech are not quite getting the point :(