Gotcha, thanks!
Since the GO is all about portability, I'm hoping to use the X-box PSU to power the whole shebang (including heated bed). The laptop-esque PSU (must put out 6 A?) it came with is actually sufficient (barely one imagines) to run the bot with the heated bed even although I've only risked PLA temps thus far (190 and 60, and the transformer gets pretty warn even then). Fingers crossed that203 Watts will be sufficient for ABS.
Thanks again for your help!
Since the GO is all about portability, I'm hoping to use the X-box PSU to power the whole shebang (including heated bed). The laptop-esque PSU (must put out 6 A?) it came with is actually sufficient (barely one imagines) to run the bot with the heated bed even although I've only risked PLA temps thus far (190 and 60, and the transformer gets pretty warn even then). Fingers crossed that203 Watts will be sufficient for ABS.
Thanks again for your help!